![]() Hopefully, the next version of Windows provides a better resolution to this issue with the loopback adapter and being able to change the network profile / location. But following the above instructions to start the virtual machine and disable/reenable the adapter on the host, should resolve this each time.) (When the host machine first comes up, since your virtual machine is not running, Windows 7 things that once again it's on a network with a different gateway mac address. Disable Loopback Adapter: Try disabling the Microsoft KM-TEST loopback adapter temporarily to see if it resolves the issue. ![]() You can adjust the network adapter priority by going to Settings > Network & Internet > Change adapter options. Once connected, data transmitted through the cable will be received back by the same device via the loopback adapter. Check if the loopback adapter is set as the default network adapter for some reason. The other end of the cable can be connected to the desired Ethernet port on a switch, router, or network device. Whenever you restart your machine, you'll again of course need to disable/reenable your loopback adapter after you've started the virtual machine. To use an Ethernet loopback adapter, simply attach it to one end of the Ethernet cable. Once Windows 7 sees the mac address on the virtual machine, you should be able to change the network profile / network location. Since Windows 7 is relying on the mac address of the virtual machine to identify the network, your virtual machine will need to be running and then you can try to disable / reenable the loopback adapter on the host machine to try to force Windows 7 to update itself. But following the above instructions to start the virtual machine and disable/reenable the adapter on the host, should resolve this each time.) Hopefully, the next version of Windows provides a better resolution to this issue with the loopback adapter and being able to change the network profile / location. You may need to disable / reenable the adapters on both machines before Windows 7 realizes it now has a mac address to identify this network with.So the IP on the virtual machine would be 1.1.1.2 and the gateway would point to your host, or 1.1.1.1. Type ipconfig /flushdns and select Enter. ![]() Type netsh int ip reset and select Enter.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |